Kemper 620, Инструкция по установке и эксплуатации

Страница: 39 / 60

K410062000000-00 / 05.2017 19
6 Materials
Materials
Controller housing ABS
Water sensor line PVC
Water sensor pin Brass, nickel plated
7 Accessories | Wiring list
7.1 Accessories
Optionally available accessories
Water sensor 2 m Figure 620 00 001
Insulating shells for Isolating valve Figure 471 19 DN 15 - 32
KHS Isolating valve with servo drive 230 V Figure 686 04 DN 15 - 32
KHS Isolating valve with spring-reset
servo drive 230 V
Figure 686 05 DN 15 - 32
KHS Isolating valve with spring-reset
servo drive 230 V
Figure 685 15 DN 32 - 50
KHS Drain with overflow monitor Figure 688 00 DN 20 - 32
7.2 Wiring for KEMPER components with electrical connection
The following list is only an example of application. The exact layout of the corresponding wiring
must be installed on site by the planner depending on the ambient conditions (temperature,
accumulation, installation type, mechanical load).
Designation For Figure o. Cable cross-section
max. cable
length
Cable type*
[-] [-] [mm²] [m] [-]
KHS PLUS Isolating valve with
spring-reset servo drive (24 V)
686 01 015…032
3 x X mm²
(power supply)
+
2 x 2 x 0,80 mm² **
(position feedback)
150 (X=1,50)
300 (X=2,50)
500 (X=4,00)
NYM-J
+
J-Y(ST)Y
KHS Isolating valve with servo
drive (24 V)
686 00 015…032
3 x X mm²
(power supply)
+
2 x 2 x 0,80 mm² **
(position feedback)
80 (X=1,50)
150 (X=2,50)
250 (X=4,00)
NYM-J
+
J-Y(ST)Y
KHS PLUS Isolating valve
with spring-reset servo drive
(230V)
686 05 015…032 3 x 1,50 mm² 1000 NYM-J
KHS Isolating valve with
servo drive (230 V)
686 04 015…032 3 x 1,50 mm² 1000 NYM-J