Keller ITS CellaPort PT 120, Руководство по эксплуатации, Страница: 30 / 72

Operating manual PT 11x, 12x,13x
24
TSP~
Plausibility
threshold **
For ATD function, see Chap. 13.2.3
ANO
Mode of display **
T=0
show lower limit of temp. range dur-
ing running measurement
T.HLD Hold previous temp. reading during
running measurement
A.RST
Auto reset**
For ATD function, see Chap. 13.2.3
CH.L.2
Set Li2 check on tAct**
For ATD function, see Chap. 13.2.3
END
End
exit menu
* Only available with Min/Max and Double Max modes
** Only available with ATD function

14.1.2 Configuration I/O (Configuration layer:
C010
)
In the factory default configuration, all parameter settings for digital in-
puts and outputs will be hidden.
Parameter Function Explanation
TYPE
Operating mode/
measuring technique
L1
Lambda 1
LED.
LED (green)
OFF OFF
ON
ON

LED.S
LED: define source
RDY
Status LED indicates ‘ready’
L1
Lambda 1
L1.PR. Lambda 1 without peak picker
TU Device inner temperature
A.TR.1
Measuring time ATD Lambda 1**
A.AC.1 Messzeit vom ATD Funktion Lamda
1**

LED.F
LED function
LVL.
Switch direction “Level” (LED acti-
vated if limit exceeded)
LVL.-
Switch direction “Level” (LED
/ out-
put inverted)
RN6.
Switch direction “Range” (LED acti-
cated if range exceeded)
RN6-
Switch direction “Range” (LED / out-
put inverted)

LED.T
LED switching thresh-
old
Switching threshold
(only available at function “Level”)

LED.H
LED signal threshold
Hyst/- relative to signal threshold
(only aviable at function “Level”)

LED._
LED lower limit of
range
Lower limit of range for switch signal
(only available function “range”)

LED.~
LED upper limit of
range
Upper limit of range for switch signal
(only available function “range”)

LED.L
LED delay time

LED.M
LED hold time

BU2.
Buzzer
OFF OFF
ON ON

BUZ.S
Buzzer: define source
RDY Status Ready-Signal
L1
Lambda 1

L1 = Lambda 1 = temperature reading from spectral channel 1