kelda BubbleSpa 95005000, Руководство пользователя

Страница: 25 / 28

Troubleshooting
BubbleSpa Showerhead
Before troubleshooting, ensure that the correct installation, usage and maintenance procedures have been followed.
Improper installation and improper use of the product can cause a lot of issues. The guide below is designed to help identify
and solve minor issues which may occur. If the issue is still not resolved, please contact Kelda Customer Service:
info@keldashowers.com
+44 (0)2381 290640
DO NOT disassemble the BubbleSpa showerhead beyond the instructions contained in this manual. Disassembling the
BubbleSpa showerhead will invalidate the warranty.
Symptom
Likely Cause Action/ Remedy
Poor/ No water flow: Hot or cold water supply isolation
valve closed
Blocked filter
Mixer valve not functioning.
Check and open valve
Unscrew the BubbleSpa showerhead from
the arm, remove and clean filter, replace filter.
Clean the mixer valve filter
Check mixer valve
Water flows from showerhead
but no air:
No power to the fan
Fan Damaged
Debris in fan
Check power light indicator, if off contact a
qualified electrician
If power light indicator is on, conduct hard
reset by switching off electrical supply and
waiting 10 seconds before turning on.
Use Diagnostic Function to see if the fan is
working. If not, contact Kelda
Clean the Dust Filters
One/ a few nozzles aren’t
making bubbles: No laminar flow through nozzle
Faulty nozzle is blocked
Insufficient water supply
Gently brush a finger against the nozzle whilst
the shower is running
Descale the showerhead to remove debris
(see page 23). Check the filter is installed
correctly (both the showerhead and valve) and
clean
Increase the water flow to the shower.
Multiple/ all nozzles aren’t
making bubbles
Insufficient water supply
Limescale/ Debris build up in the
nozzles
The fan wont turn on below 6L/min therefore
no bubbles will be produced. Increase the
water flow to the shower.
Clean the BubbleSpa showerhead (see
page 23). It is reccomended not to leave the
BubbleSpa showerhead unused for more than
2 weeks.
Water flow too strong:
Flow restrictor not installed.
Check if the flow restrictor is properly installed
(see page 23)
25