26
DOC06179 Rev. B
OWNER / OPERATOR MANUAL
RUNNING FLOOR II
®
DX / DXE
6. Insert the yellow power-on key into the transmitter. The status indicator LED will start blinking.
Transmitter Status Indicator:
Green
: Battery power sufficient
Red
: Battery power low. Requires 4x AA (1.5V) alkaline or nickel rechargeable batteries.
7. The remote transmitter is now ready for use.
UNLOAD:
Push and release the “UNLOAD” button on the remote transmitter. The floor
will continue to move until he “UNLOAD” button is pressed again.
LOAD:
Push and hold the “LOAD” button. The floor will continue to move until the
button is released.
LEFT / RIGHT:
These buttons can be used for other functions, for example retracting a
KEITH Walking Floor Sweep System. Pushing and holding one of these
buttons activates the function until the button is released.
⚠
CAUTION: While unloading, NEVER leave truck and trailer unattended.
⚠
WARNING: Do not go under the truck or trailer body or enter the truck or trailer while the
system is in operation, nor allow anyone to stand or move through the area where the load is being
discharged. Burial, loss of limb or life may occur.
8.
After loading/unloading has been completed, stop the floor with all slats in the forward position.
Turn off the remote control by pushing the EMS button and remove the power-on key from the
transmitter.
9. Turn off the receiver by pushing the EMS button.
10. Disengage PTO and return the truck engine to idle.
11. Close and secure the truck or trailer doors.
12. Disconnect and secure the hydraulic hoses (If applicable).
EMERGENCY STOP:
In case of emergency the floor can be stopped in one of the following ways:
• Push the red EMS (emergency stop) button on the transmitter or receiver.
• Remove the yellow key from the transmitter.
• Disengage the PTO / Pumping System.
• Cut the electric power to the receiver.
IMPORTANT NOTE:
The KEITH wireless remote control has some built in features:
•
The floor automatically stops moving if the continuous signal link, between receiver and transmitter,
is not detected.
• The wireless remote control automatically turns off after 10 minutes of continuous use.
Содержание KRFII-3
