21
DOC06179 Rev. B
OWNER / OPERATOR MANUAL
RUNNING FLOOR II
®
DX / DXE
3.7 Manual Controls
1. Set parking brake on truck and trailer.
2. Open truck or trailer doors fully and secure doors with provided chains or loop rings.
⚠
CAUTION: ALWAYS have doors fully open! Do not, under any circumstances, engage the Power
Take Off (PTO) / Pump System or
WALKING FLOOR
® unloader with the doors of the truck or trailer
closed. Catastrophic failure to the trailer, as well as serious injury or death may occur.
3.
Inspect hydraulic hoses and quick connects for damage, then connect the floor to the truck wet
kit (If applicable).
4.
Engage the PTO, then bring the truck engine up to the RPM to achieve desired flow rate from
the wet kit.
5.
Place control valve (See figure below) in the required position for the desired direction of
material movement (Unload/Load).
6.
Pull the ball valve (See figure above) fully closed. It is located between the pressure and return
lines. Your truck or trailer floor should now be operating.
NOTE:
This ball valve controls (On/Off)
and is used as an emergency shut-off.
⚠
CAUTION: While unloading, NEVER leave truck and trailer unattended.
⚠
WARNING: Do not go under the truck or trailer body or enter the truck or trailer while the
system is in operation, nor allow anyone to stand or move through the area where the load is being
discharged. Burial, loss of limb or life may occur.
7.
After loading/unloading has been completed, stop the floor with all slats in the forward position
by pushing the ball valve to the fully open position.
8. Disengage PTO and return the truck engine to idle.
9. Close and secure the truck or trailer doors.
10. Disconnect and secure the hydraulic hoses (If applicable).
EMERGENCY STOP:
In case of emergency the floor can be stopped in one of the following ways:
• Disengage the PTO / Pumping System.
• Push the ball valve fully open.
⚠
CAUTION: Observations may be made while system is operating for troubleshooting purposes,
but NEVER touch any moving part or attempt to make any adjustments to the system with the Power
Take Off (PTO) / Pumping System engaged or the
WALKING FLOOR
® unloader operating.
Содержание KRFII-3
