Assembly requires two people. Set the TrekMill in a clear area and remove all packing materials.
Do not dispose of the packing materials until assembly is complete. Assembly requires the Allen
wrenches provided, a Phillips screwdriver
and a 13mm open-ended wrench.
4
1.
Identify the right upright
[1]
. Insert upright
harness
[2]
into upright and pull the excess upright
wire harness out of the top of the right upright. Slide
the right upright onto the base. Be careful not to pinch
the wire harness.
Finger tighten six bolts
[3]
(four on outside of upright
and two on the inside) with washer and star washer
into the upright
[1]
.
Note:
It may be necessary to move the upright slightly
to align the holes.
Attach the left upright (not shown) in the same way.
Note:
There is no wire harness in the left upright. Do
not tighten the upright bolts
[3]
yet.
2.
Place the console
[4]
on each upright
[1]
. Make
sure the console is turned as shown in the drawing.
Connect the console wire harness
[5]
to the upright
wire harness
[2]
and insert both wire harnesses into the
right upright
[1]
.
Tighten two console side bolts
[6]
into the top of the
upright and console. Repeat this procedure on the
other side. Use 13mm wrench to tight these bolts.
Assembly
