![background image](http://html1.mh-extra.com/html/keiser/m3-tbt/m3-tbt_user-manual_3931528006.webp)
7
6
ASSEMBLING FLYWHEEL, HUB, AND HUB CAP
Step 1
: Before starting the assembly of the flywheel, hub, and hub cap, make sure that
the shifter lever is in the downward position. (Fig. 6)
NOTE:
Not following this step may scratch the flywheel.
Step 2
: Remove the plastic wrapping from around the axle, hub, and hub cap. Remove
the hub cap and set it aside along with the five socket head cap screws (N1). Remove
the plywood protector Remove partial of the flywheel from its foam envelope leaving the
foam envelope to grab the flywheel with.
Step 3
: Carefully slide the flywheel between the two magnets (Fig 7. & Fig. 8) and onto the
hub at the same time. Make sure that the flywheel is flush against the hub and align the
screw holes.
NOTE
: Use the foam envelope to handle the flywheel during assembly.
Step 4
: Holding the flywheel in position with one hand, install the hubcap and align the
screw holes. Install the socket head cap screws (N1). Using the 5mm Allen wrench, tighten
the screws in a star pattern until snug (as shown in Fig. 9).
8
9
Содержание m3 TBT
Страница 1: ...USER MANUAL ...