POWER RACK ASSEMBLY INSTRUCTIONS
13
Power Display
with Neck Mount
6
INSTALL REAR CROSS BRACE AND TOP POWER DISPLAY
A
Route Communication Wire with Coupler through Display Port and install the Rear Cross Brace.
Connect and install the Top Power Display. Check for Proper Connection. NOTE: Air Compressor not required to turn
on the Power Display.
Turn on the Power Display by momentarily pressing both
+
and
–
Foot Pedals.
RESISTANCE
window change from
OFF
to
CLEr
>
0
= proper connection.
B
Communication Wire
IMPORTANT
: Click sound
confirms proper connection.
Power Display enters sleep mode
(OFF) after 1 minute of inactivity.
If the Power Display does
not turn on, check the
Communication Wire connection.
IMPORTANT
: BEFORE INSTALLATION,
CHECK BOLTS AT THE BASE OF THE POSTS ARE NOT FULLY
TIGHTENED TO ALLOW FOR EASY BOLT HOLE ALIGNMENT.
IMPORTANT: DO NOT TIGHTEN BOLTS TO
ALLOW FOR EASY BOLT HOLE ALIGNMENT.
Rear Cross Brace
with Display Port
(rear view)
