23
HALF RACK OPERATION MANUAL
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
US FCC COMPLIANCE STATEMENT
DISPOSAL
ELECTROMAGNETIC COMPATIBILITY (EMC)
EMC Notices — Statement of Compliance
This product has been determined to be compliant with the applicable standards, regulations, and directives for the countries
where the product is marketed.
Compliance documentation, such as Declaration of Compliance for the product, are available upon request by contacting
. Please include the product, model number identifiers, and serial number and country that compliance
information is needed in request.
Korea
“This equipment is for home use and has acquired electromagnetic
conformity registration, so it can be used not only in residential
areas but also other areas.”
DISPOSAL
This equipment contains electrical or electronic components, alkaline batteries, and a sealed lithium coin cell
battery that must be disposed of properly to comply with the EU Directive on disposal of waste electrical and
electronic equipment (EU WEEE Directive 2002/96/EC).
Contact an appropriate waste disposal company upon the equipment’s end of service life. Disposal must be in accordance
with respective national regulation.
Wear parts: After being replaced, wear parts must be disposed of according to country-specific waste laws.
If you have any questions about equipment disposal, please contact your local dealer or Keiser Customer Support (see
back cover for contact information)
.
