Kegel FLEX 17-5701, Руководство оператора

Страница: 72 / 303

60
Buffer Belt
Adjustment of the Buffer Belt is done with the buffer
brush in the down position.
Loosen up the idler pulley and push it all the way up
and fasten tight, do not over tighten belt.
This idler roller is used to keep
belt from jumping cogs. It uses an eccentric adjusting sleeve to adjust
it closer or farther from the belt. Loosen bolt and turn sleeve to adjust,
rotate brush to make sure roller is not pinching belt too tight to pulley
before tightening bolt. Always inspect for good belt alignment from
motor to brush pulley.
Transfer Brush
The following steps adjust the transfer brush to the buffer brush.
1. Loosen the four ¼” jam nuts on each square head bolts and back them away so that
the transfer brush can move all the way in and out of the buffer brush assembly.
2. Loosen the five ¼-20 bolts on the front side that secure the adjustment bar, but keep
them snug.
3. Using a ¼” wrench, screw the square headed bolts into the Transfer Brush to lower.
Do this until the Transfer Brush just contacts the buffer brush assembly. Once this
happens, turn the screws two full turns and tighten them all the way.
Transfer Roller
1. With the machine in the operating position, loosen the
roller pivot screws.
2. Then loosen the jam nut on the Roller adjusting screw
and turn the screw in or out until the
1/8” – 3/16” crush is obtained by turning the adjustment
screws OUT, INCREASES THE CRUSH, by turning the
screws IN, DECREASES THE CRUSH.
3. Tighten the jam nut and the pivot screws back into
place.
Adjusting screw
Pivot
Idler Pulley