Kegel FLEX 17-5701, Руководство оператора

Страница: 154 / 303

142
With a flathead screwdriver remove the drive motor brush
cap and remove the brush. It may be necessary to pry this
out with small screwdriver.
Next, with the machine standing up, remove the opposite
side drive motor brush.
With the machine in the upright,
transport position, you will have access through the bottom plate
of the lane machine.
Once both motor brushes have been removed, take an air
compressor and blow out the carbon residue that may have built
up over time.
The FLEX Walker will have an additional drive motor to blow out. This motor is located in
the center compartment under the electrical panel. To
do this, it will be necessary to remove the conditioner
compartment lid assembly as well as the cleaner
compartment lid. Refer to Chapter 1 for removal of lids.
Once the lids have been removed, remove the three
screws on the back side of the hinged electrical panel. Tilt
the electrical panel up towards you to view the top of the
drive motor brush cap. Remove the drive motor cap
followed by the drive motor brush.
Note: The 7 pin drive motor does not operate as often as the 10 pin motor, so the need to do
this often is not needed unless trouble shooting a drive problem.