Kegel FLEX 17-5701, Руководство оператора

Страница: 121 / 303

109
If the Cushion Roller shows excessive wear, it will be necessary to replace the entire
assembly.
Changing Duster Cloth
The machine uses a patented Dual Motor Ratcheting (DMR) Cloth system. The duster
assembly operates by means of two brake motors. The first unwinds cloth and sets the
cushion roller down on the lane surface. The second winds up used cloth onto the used
core.
The wind-up motor also lifts the cushion roller off the lane at the end of the run. This dual
action simulates that of a ratcheting duster, helping to eliminate dirt lines during a
conditioning run. This system also controls cloth usage better and has no clutch
mechanism to adjust.
IMPORTANT! The machine can NOT be operated without Cleaning Cloth installed.
Lane Cleaning Cloth should be loaded into the machine using the following procedure:
1.
Remove the cleaner & Pindeck treatment dispensing tip from the holder and then
remove the old cloth
(make sure the spring in the tip holder block doesn’t fall out)
.
2. Now that the cloth is out of the way, take this opportunity to clean and maintain this
compartment. The cleaner belt should be inspected and the sliding head bar lubricated
at this time.
3. Remove the pipe from the old duster core and insert into the new one. Unroll about 3
feet of cloth and then install the new roll into its location.
4. Route the cloth down between the squeegee and the cushion roller. Pull the cloth under
the cushion roller and distribute it evenly.
5.
Once the cloth is routed under the cushion, pull the excess cloth
far enough through to get at least 3 or 4 wraps around the PVC
take-up reel or EZ Core. Make sure the cloth is wrapped evenly
from side to side around the pipe.
6. Insert the take-up reel into its location and
replace BOTH
dispensing tips.
7. Locate the motor button in the cleaner compartment; this
button is always enabled to operate the duster (unless the
cleaner volume is being checked). Press the button once and
the duster will unwind, press again and the duster will wind-up
the cloth. The cloth should be rolled up tight and evenly across
the assembly.
VERY IMPORTANT! After installing the new roll, you must reset the
number of lanes on the cloth. You can do this by pressing and
holding the function button until you hear 3 beeps followed by a
steady beep, then release. Or, going to your duster settings in the
menus and press RESET CLOTH.