INSTALLATION
Speedster
page 6
Unpack
Tools needed
Phillips screw driver no. 2
Procedure
1.
Remove the lid of the crate.
2.
Remove the side panels.
3.
Lift the machine by its legs.
Warning!
The valves at both sides of the group are not designed to lift the machine. Lifting the
machine by these may cause the frame to bend which results in unrepairable damage.
Installation
Parts needed, included in shipment
Machine
Water softener, height 40 cm (16 inch), diameter 19 cm (8 inch), taps protrude 7
cm (3 inch)
Brass fitting
2 high pressure hoses, each 1.5 m (5 ft)
1 high pressure hose, 0.5 m (20 inch)
Pump with motor, 29x14x19 cm (length x width x height; 12x6x8 inch)
Discharge hose with stainless steel clamp
Tools needed
Spanner 20-22 mm
Spanner 18-19 mm
Spanner 30 mm or adjustable spanner
Teflon tape
Screw driver
Sharp knife
Side cutter
Bucket
Connect water supply
1.
Tighten the special brass fitting to the washing machine tap with a 30 mm or
adjustable spanner. Apply a few windings of Teflon tape on the tap first to
eliminate leakage.
2.
Use a 20 mm spanner to attach one end of a long high pressure hose to the fitting
on the tap. A gasket is not needed, the ball-shaped brass end will seal upon
tightening. Use a 30 mm spanner on the brass fitting to refrain it from tightening
further.
3.
Attach the other end of the high pressure hose to the upper tap on the water
softener (see figure 2). Tighten with a 20 mm spanner while securing the tap with
a 19 mm spanner. Do not use excessive force.