INSTALLATION
Speedster
page 8
first; this is from the resin in the water softener and is harmless. Flush until the
water runs clear.
8.
Close the washing machine tap and connect the loose end of the high pressure
hose to the water connection on the bottom of the Speedster with a 20 mm
spanner. The Speedster may be tilted in such a way that it rests on the two hind-
legs and the back of the machine, see figure 4.
Figure 4. Speedster is tilted on its back, water supply is connected. Discharge pipe is
indicated.
9.
Re-open the washing machine tap and check the earlier made connections for
leakage. Tighten when needed but do not use excessive force. In the meantime,
the front (coffee) boiler will fill with water.
Connect water discharge
1.
Position the stainless steel hose clamp on one end of the discharge hose. Slide the
end of the hose over the discharge-pipe of the drip tray (see figure 4) and tighten
the hose clamp.
2.
Insert the other end of the discharge hose into the sewer or a discharge
container.
Beware!
To prevent sedimentation of smudge, the discharge hose should slope
down to your sewer or discharge container over the entire length of the hose.
3.
When necessary, cut the discharge hose to desired length (cut the inforcement
with side cutters).
4.
Put the Speedster back on its feet.
discharge pipe
water supply