���
Attach the
Joining brackets
to the
legs
Using the
spacer
, fit the
joining brackets
to the top of each
leg
NOTE:-
Ensure the
joining brackets
are fitted the correct
way round.
���
Make the
Centre frame
Assemble the frame using the
beam with holes
and the other single
beam
of the same length. ensure the
beam with holes
is assembled
the correct way round (
see diagram
)
Tighten all the
grub screws
using the long end of the
allen key
. ensure
there are no gaps between the ends of the
beams
and the
legs
, then
lock the
grub screws
using the short end of the
allen key
.
���
Change the frame on your existing unit
Remove the worktop from your existing unit then:-
Either
Remove the
dividing rods
and
dividing rod supports
from
your existing unit
Or
Hold the
dividing rod supports
in place with a length of timber
fixed to the unit with strong tape or string.
Remove the
screws
and
washers
attaching the
dividing rod supports
to the end frames.
Put
grub screws
in each of
the two large holes in every
bracket
, only screw them in
by 2 or 3 turns.
HOLES TOWARDS
THE BACK
REMOVE SCREWS AND
WASHERS
SIDE TO BE EXTENDED
TIMBER
FRONT LEG
BACK LEG
TIMBER
TAPE OR
STRING
BACK LEG
FRONT LEG
