22
QUICK SETUP INSTRUCTIONS, continued
STEP 5
–
Raise Crimper Body, then secure vial into Head
using Height Setup Knob.
A.
Set an empty vial on the Rubber Pad
of the Vial Holder, then turn the
Height Adjustment Dial (A) clockwise
to raise the Crimper Body until there
are approximately 2 inches of
clearance between the bottom of the
Head and the top of the vial (refer to
diagram on page 8).
B.
Place a seal on the vial, and hold the
vial up into the Head (B) as far as it
will go with your left hand.
C.
With your right hand, pull the Crimp
Lever (C) forward until it stops and
hold it there. Let go of the vial so that
it is held only by the Head.
D.
Still holding the Crimp Lever (C)
forward, use your left hand to push
and hold the Height Setup Knob (D)
inward.
E.
Gently let go of the Crimp Lever (C)
(which should now stay in the forward
position), then let go of the Height
Setup Knob (D). The Height Setup
Knob should stay pushed inward, and
the vial will remain in the Head for
the next step.
A
C
D
B
