KC-P30 x-series
Configuration
Configuration manual V4.09
19
© KEBA
Adapt file name
The file name contains the serial number of the charging station from which
the configuration was read out. This serial number must be deleted from the
file name.
A configuration file without a serial number in the file name can be used to
configure multiple charging stations. If the configuration is to be valid for only
exactly one charging station, the file name must contain the serial number of
the desired charging station.
Adapt content
The specific configurations that only apply to one charging station must be
adapted or deleted in the configuration file.
All settings are listed in the configuration file. The figure below shows a sec-
tion of a configuration file. To the left of the equal sign "=" is the name of the
setting. To the right of the equal sign is the set value.
Fig. 3-5: Section of a configuration file
To adapt and delete the specific configurations, proceed as follows:
1) Open the configuration file with a text editor.
2) Adapt the following entries:
►
AmountConnectors=[x]
The number of charging stations in the charging network must be
adapted here.
3) Delete the following entries completely:
►
ChargeBoxIdentity=[xxx]
►
Connect2ConnectorSerial[x]=[xxx]
►
HOTSPOT_SSID=[xxx]
►
HOTSPOT_KEY=[xxx]
4) Save the file.
