KEB COMBICONTROL C6 HMI, Инструкция по эксплуатации

Страница: 65 / 88

65
The CONTROL Runtime running on a C6 HMI LC device can be reached also from a
panel which has been configured to belong to the same sub network.
When having on the same sub network more than one C6 HMI LC system, you need
to assign to them different name.
Note : In case the CONTROL Runtime is using Ethernet based I/O, the COMBIVIS stu-
dio HMI project must not be configured to use Ethernet protocols. The “LAN” inter-
face is exclusively dedicated to the I/O, while the “WAN” interface is dedicated to
the Internet connection for COMBIVIS connect and cannot be used as protocol port.
Note : The COMBIVIS studio HMI project can be configured to communicate with
more than one controller; in these cases the system can act as a gateway and trans-
fer data through the different channels. For further information about this feature
consult the COMBIVIS studio HMI on-line manual searching for “Variable Com-
mands” and then “Move Value”.
5.2.7 Use in combination with COMBIVIS connect
The C6 HMI LC systems are featuring COMBIVIS connect Runtime as preloaded and
pre-configured.
The COMBIVIS connect VPN connection can be naturally used to connect from re-
mote to the CONTROL PLC through the integrated Gateway. Once the VPN is acti-
vated, just follow the usual steps to get the on-line connection.
Please see the COMBIVIS connect Control Center on-line manual for further infor-
mation about how to use the COMBIVIS connect software.