KEB COMBICONTROL C6 HMI, Инструкция по эксплуатации

Страница: 61 / 88

61
5.2.3 Transferring the COMBIVIS studio 6 application to the
target system
To transfer a valid COMBIVIS studio 6 application to the Target system, follow these
steps:
- Ensure the C6 HMI LC device is connected to the same sub network of the
PC where you have running the COMBIVIS studio 6 programming tool
(same network mask, e.g. “192.168.1.xx”)
- Double click on the device icon from the COMBIVIS studio 6 project tree;
the right part of the workspace will show the “Communication settings”
tab contents
- Select the Gateway and click on the button “Scan network” button
- The box will be populated with the list of available CONTROL Runtime
- Click on the one you want to connect too and click then on the “Set active
path” button
- Click On-line\Login to start the communication
5.2.4 I/O Fieldbus
The implementation “CONTROL Runtime” for KEB C6 HMI LC systems supports the
following I/O fieldbuses:
- EtherCAT with NO DC support (distributed clock) on LAN1
- Modbus TCP on LAN1
- Modbus RTU
To insert the I/O master right click on the C6 HMI LC device icon on the project tree,
select “Add Device” and select from the “Vendor” list box. The list will be populated
with the available master devices. Select the one required by your application in be-
tween:
- EtherCAT Master
- Modbus COM (for Modbus based I/O both serial and TCP)
C6 HMI LC systems are featuring two Ethernet interfaces.
The interface that must be used for I/O fieldbus is the one denominated “LAN1”.
Note : At the moment of transferring the PLC application to the target system,
COMBIVIS studio 6 will ask to which interface the I/O must be attached. You must
specify the MAC address of the “LAN1” interface as shown in the following figure.