12
E)
Install Canopy to Motor Assembly /
Ԋ၆ဋᇐՍีଢ଼ᐠಢӇ
1
1
Remove the Screws, and separate Canopy as shown.
如圖所示拆除螺絲並分開罩蓋。
Canopy /
罩蓋
Screw /
螺絲
Press /
按
Remove the Screws /
拆開螺絲
Pull /
拉
2
2
Take the Canopy (2 pieces) and place towards Hanger Plate Assembly as shown. (Canopy fi xing direction follow to
diagram as shown below.)
取罩蓋（
2
片）並如圖所示朝吊板組件放置。(請遵循下圖所示的罩蓋安裝方向。)
Make sure Canopy is installed above Hanger Plate Assembly and clipped until the “click” sound is heard.
確定罩蓋被安裝在吊板組件之上並夾住直至聽到“喀噠＂聲。
< Top View - For Viewing Purpose Only > /
<
頂視圖 - 供參觀之用
>
Hanger Plate Assembly /
吊板組件
Canopy /
罩蓋
Concrete Ceiling /
混凝土天花板
Concrete Ceiling /
混凝土天花板
Canopy /
罩蓋
“Click”
喀噠
ATTENTION /
ཎ
It is recommended to user, to install an OFF/ON switch on the wall for the Ceiling Fan, replacing existing regulator or new
regulator point. If your Remote Control missing or misplaced, the Ceiling Fan can be switched on at pre-set speed 2.
建議用戶將吊扇的
OFF/ON
開關安裝在牆壁上，替換現有的調節器或新的調節點。若您的遙控器不見了，吊扇可以以預設速
度
2
開啟。
ATTENTION /
ཎġ
Make sure Canopy installation is as shown in the diagram. /
務必遵循圖示安裝罩蓋。
Can cause Canopy to be damaged after screw is fi xed. /
鎖上螺絲後會導致罩蓋損壞。
R48SP.indd 12
R48SP.indd 12
4/15/2013 5:20:43 PM
4/15/2013 5:20:43 PM