10
4
4
Reinstall Hanger Supporter (from step B-3 Page 6) on the Hanger Plate Assembly and screw it fi rmly as shown in the
diagram.
重新安裝吊架支架(請參閱第
6
頁步驟
B-3
)於吊板組件並如圖所示將之鎖緊。
Hanger Supporter /
吊架支架
Hanger Supporter Screw /
吊架支架螺絲
Concrete Ceiling /
混凝土天花板
5
5
Join Connector A (from Motor Assembly) to Connector B (from Hanger Plate Assembly).
將連接器
A
（從發動機組件）連接至連接器
B
（從吊板組件）。
Connector A /
連接器
A
Connector B /
連接器
B
“Click”
喀噠
D)
Wiring Instruction /
ጣࡾҰ
1
1
Connect the wires to the house supply line according to diagram shown.
如圖所示將電線連接至家裏的電源線。
Please use splice if using Terminal for installation.
若使用端子進行安裝，請使用接頭。
CAUTION /
ݧཎ
Electrical wiring must be done by qualifi ed personnel.
Can cause fi re, electrical shock, Ceiling Fan to drop
and injuries.
電線配線工作必須由符合資格的人員進行。
可以導致火災、電擊、吊扇掉落及受傷。
WARNING /
ឌ֙
Do not bypass and short circuit the Safety Switch.
Can cause fi re, explosion, short circuit, and electrical shock.
切勿繞過和短接安全開關。
這可導致火災、爆炸、短路及電擊。
Check Point After Installation /
Ԋ၆ࡣޟᔮᡛᘈ
Check /
ᔮࢥ
1. Ensure the position of Ball Joint Holder is pressing on the top of the Switch Cover as shown.
(If the Ceiling Fan is unable to operate due to misalignment of the Ball Joint Holder, adjust the Ball Joint
position until the holder is placed right on the top of the Switch Cover).
如圖所示，確定球形接頭固定點的位置壓在開關罩的頂端。
（若吊扇因為球形接頭固定點位移而無法操作，調整球形接頭的位置直至固定點位於開關罩的正頂端）。
2. Ensure the Hanger Supporter is screwed fi rmly to the Hanger Plate Assembly.
確定吊架支架已鎖緊至吊板組件。
3. The Safety Wire is securely fi xed to the Carl Bolt and screwed to the Motor Shaft.
將保險線固定至卡爾螺栓並鎖至發動機轉動軸。
Concrete Ceiling /
混凝土天花板
Green/Yellow (Earth) /
綠色/黃色（地線）
Brown (Live) /
棕色(火線)
Blue (Neutral) /
藍色（零線)
R48SP.indd 10
R48SP.indd 10
4/15/2013 5:20:42 PM
4/15/2013 5:20:42 PM