- 20 -
Maintenance of Muffle
In case to clean the stuck metal and the debris on the surface of muffle and
●
to replace the consumables, we recommend you to refer to the following
diagram.
Note Make sure that main power is off and muffle heat is sufficiently low before you start.
)
Cross Recessed Screw
①
Used to fix muffle metal ring.
Metal Ring
②
Donut shaped metal ring to hold down the muffle part.
Metal Shutter
③
Used to place closely in contact with muffle inside wall
to prevent debris from dropping into muffle.
Metal Plate
④
A specific metal plate to protect muffle when casting
ring touches muffle top surface.
⑤
(
)
Ceramic Ring, small consumables
Heat insulating ring in grey to fix retort.
We recommend you to replace the ceramic plate in
case of damaged when the retort is replaced.
⑥
(
)
Retort N.S.C consumables
Heat resistant ceramic and used to hold a crucible
with melted alloy in it. If ceramic crucible is stuck to
retort when you remove it after casting operation,
glass-like substances are gathered in the bottom of
retort. The continued use of the retort will diminish
the crucible life and we recommend you to replace.
Ceramic Plate, large
⑦
A specific heat resistant ceramic plate in grey to
maintain retort from high heat of muffle.
⑧
(
)
Fiber Sheet consumables
An insulating fiber material that intercepts high heat from muffle and prevents debris
from entering the muffle. We recommend you to replace the fiber sheet when the retort
N.S.C is replaced.
Consumables
■
The list of consumables.
Name
QTY.
10 pcs
Carbon Washer Kit
10 pcs
Carbon Crucible S.CAS
10 pcs
Ceramic Crucible N.S.C
Casting Rings 1 3/4" diam.
43mm
3 pcs
(φ
)
Casting Rings 2 3/8" diam.
60mm
3 pcs
(φ
)
Casting Rings 3" diam.
76mm
2 pcs
(φ
)
Casting Rings 3 1/2" diam.
90mm
1 pc
(φ
)
Sprue Formers 1 3/4" diam.
43mm
3 pcs
(φ
)
Sprue Formers 2 3/8" diam.
60mm
3 pcs
(φ
)
Sprue Formers 3" diam.
76mm
2 pcs
(φ
)
Sprue Formers 3 1/2" diam.
90mm
1 pc
(φ
)
Crucible Former
100 pcs
Retort N.S.C
1 pc
Ceramic Ring
1 pc
