- 15 -
Program Duplication Mode
■
This function is used when you want to copy a program to another program
memory slot. The following example shows to transfer the program on course
12 to course 25.
1. Press the
button in stand-by mode to display course
.
Select Original Program
∧∨
2. Press the AUTO. PROGRAMMING and PROGRAMMING button
simultaneously.
The lamps of the AUTO. PROGRAMMING and the PROGRAMMING buttons will
・
turn on and off.
3. The 4 digit display will read
. Press the
button to change the
∧∨
means Copy.
display to read
.
4. Press the OK button to activate program copy and displays the course 25
to finish program copy.
Note If no button press done for approx. 10 seconds, the unit returns to stand-by mode to
)
release the duplication mode.
Default Value Set Mode
■
Press the OK button while you hold down the SELECTOR button and
initial is displayed briefly to enter the default value set mode that
(
)
includes the following value settings.
1. Chime volume level of notification and warning when button is pressed.
2. Temp increase set when the +TEMP button is pressed.
3. Choice of the increased melt temp to save in the program or not.
4. Altitude of unit location setting.
(℃
)
5. Set of temperature unit of measure
/
Muffle Heat Correction
6.
Chime Volume
Button entry volume
●
・
The chime level set of button entry is available.
(
)
Display
Default Value
Press the
button to display the desired value on the 4 digit display
∧∨
and press the OK button to enter and to shift to the next program
parameter.
Mute
：
Low
：
Medium
：
High
：
Error and Finish chime volume
・
(
)
Display
Default Value
Press the
button to display the desired value on the 4 digit display
∧∨
and press the OK button to enter and to shift to the next program
parameter.
Mute
：
Low
：
Medium
：
High
：
