- 10 -
2. Manual Program Mode
This mode is to input each parameter necessary for casting by hand.
Programming on
Using the auto program mode, we will program the following parameters on
●
Auto Program Mode
the program course No.15 to store.
Ex. Porcelain bonding precious alloy
(
℃)
Liquid phase temp.
2084
1140
(
)
Alloy melt quantity
30g 1.1 Oz.
Investment type
Phosphate
Crucible type
Carbon
1. Press the
button to bring the course display to read
.
Program Course
∧∨
Keep pressing the
button to scroll through numbers quickly.
∧∨
2. Press the AUTO. PROGRAMMING button.
The lamp of Auto Program is illuminated and the lamp of Liquid Phase Temp. is
blinking.
3. Press the
button to display
and press the OK button.
Liquid Phase Temp.
∧∨
The lamp of Alloy Melt Quantity is blinking.
4. Press the
button to display
and press the OK button.
Melting Quantity
∧∨
5. Press the
button to select Phosphate and press the OK button.
Investment Type
∧∨
Press the OK button repeatedly to scroll through each parameter quickly and to
check program or to modify.
6. Press the
button to choose Carbon crucible and press the OK
Crucible Type
∧∨
button.
7. After storing the correct 4 parameters, press the AUTO. PROGRAMMING
button to occur the 6 necessary casting parameters from the 4 parameters
stored and the unit stores the data in the memory course No.15.
The Start Temp. lamp blinks and the unit will start to heat up to the Start Temp.
Note If
is displayed, the chamber lid is closed. Open up the chamber lid.
)
Note When you do not continue further casting, we recommend you to turn the power off
)
or to select a blank programmed course, otherwise the unit will unnecessarily
continue heating up to the start temp.
Note When you desire to confirm or modify the stored 6 casting parameters, we
)
recommend you to refer to the next program mode of
Programming on Manual
｢
Program Mode .
｣
Note If any one of the parameters is missing in programming, the parameters will not
)
store the program.
