WESII User Manual
Manual-WESII-Rev1205A
Copyright © KBC Networks 2012
Page 9 of 48
www.kbcnetworks.com
POE +
P
o
w
e
r
O
U
T
IN
Local Power
Remote Power
PIM Top View
PIM Side View (Power and Output)
PIM Side View (Input)
Note:
KBC Networks’ WESII units are mid-span compliant and must be powered
using the supplied power injection module.
2.3.4
RF Module LED Description
1.
Status/Signal Strength Indicator – 40 RSSI
2.
Signal Strength Indicator – 30 RSSI
3.
Signal Strength Indicator – 20 RSSI
4.
Signal Strength Indicator – 10 RSSI
5.
Ethernet Link Activity
6.
Power
LED Boot Up Process
2.3.4.1
Upon connection of an Ethernet cable from the PIM to the unit, the Power LED
6 will light.
After 1 second RSSI LEDs 1, 2 & 3 illuminate.
RSSI LEDs 1, 2 & 3 then go off.
After 5 seconds the Ethernet Link Activity LED 5, illuminates.
At the same time the Signal Strength Indicator, LED 1 flashes for
approximately 2 seconds.
LEDs 1 & 5 then switch off.
LED 5 comes on again and flashes intermittently showing that a connection is
established.
After approximately 1 – 2 minutes RSSI LEDs 1, 2, 3 & 4 will light depending
on the level of signal strength.
Note:
WESII units with EMEA firmware set to frequencies between 5600 – 5650MHz
and any channels that overlap these frequencies may take up to 13 minutes to
connect due to the Channel Availability Check (CAC) time requirement of ETSI
Dynamic Frequency Selection (DFS). See section 6.4 for further details.
1 2 3 4 5 6
1
2
2
3
1.Power – Power supply input
2.OUT – Connect to the WESII unit
3. IN – Connect to the Ethernet device
