WESII User Manual
Manual-WESII-Rev1205A
Copyright © KBC Networks 2012
Page 11 of 48
www.kbcnetworks.com
7.
If there are multiple Host/APs and associated Clients, configure the additional
hosts as in steps 3 – 5 while noting their MAC Addresses. (including the first
host) & SSID. Each Client intended to talk with a particular Host must be
configured to connect with its host via SSID filtering under the Client’s “Remote
Preferred AP MAC” section but will not require their MAC addresses to be locked.
Additional Host MAC addresses can be inserted as fail over hosts. Refer to the
provided documentation regarding any preset configurations to match up the
correct Client(s) to the correct Host/AP to which it/they will connect.
8.
Unless more advanced set up is desired, the antennas are configured for
installation at this point. For advanced configuration see section 3.2.6.
2.4.2
Replacing / Adding a WESII Module from/to the Existing
Application
The WESII Host/AP connects to its Client(s) based on MAC Address. A Ptp Host/AP
can connect to one Client MAC Address only, whereas the Ptmp Host/AP can connect
to multiple Clients. If a Host/AP is being replaced, the Clients with which it is
required to communicate must be configured within the Host/AP System page. If a
Client is being replaced, or added to a Ptmp network, its SSID must be configured to
match the Host/AP SSID configuration (if changed from default configurations). In
addition (if replacing / adding a Host/AP from/to the existing application), the
Host/AP must be configured to an available frequency.
2.4.3
Pole and Wall-mount for Directional WESII Antennas
There are 2 different mounting brackets currently available with WESII products,
details are below:
Remove all packaging material
Connect the black mounting assembly (which has the adjustment swivel) to the
mounting L-shaped bracket with the ¼-20 button head screw.
Connect the WESII unit to the mounting assembly using the ¼” mounting hole
in the case (see figure above).
Position the WESII unit to face the WESII unit at the other end of the link.
Carry out the alignment process – see section 2.4.8 for instructions and section
2.3.4 for LED status information.
When in the best position, tighten the swivel mount.
Pole
