29
kayden.com Online Store
CLASSIC
®
800 Product Manual
Setup & Operation
Section
4
RUN MODE
- Run Mode LED is ‘Flashing’
RUN
Press and hold to view the
Software Revision
and
Node Address
SET
Press and release to enter
Set Mode
(see table below)
Left Arrow
Press and hold to view the LRV and URV on Unscaled Bar Graph
Right Arrow
Press and hold to view Thermal Signal data on Unscaled Bar Graph
1
Press and hold to view
Set Point 1
on Scaled Bar Graph
2
Press and hold to view
Set Point 2
on Scaled Bar Graph
SET MODE
- Run Mode LED is ‘Off’
RUN
Press and release to exit
Set Mode
and return to
Run Mode
SET
Press and release to proceed to next step of
Set Mode
Left Arrow
Adjust selection as per
Set Mode
function
Right Arrow
Adjust selection as per
Set Mode
function
1
No function in
Set Mode
2
No function in
Set Mode
Display Panel Button Functions
- RUN Mode and SET Mode.
Display Panel Indicators:
Relay 1
On steady when Relay 1 is energized
Relay 2
On steady when Relay 2 is energized
Fault
Indicates a self-test error or fault condition
Set Point 1
On steady when viewing Set Point 1
Set Point 2
On steady when viewing Set Point 2
Run Mode
Flashing when switch is operating
Bypass
Flashing when the Start-up Bypass Timer
is active
Thermal Signal
Displays Thermal Signal
The Thermal Signal increases as:
Flow
The flow rate increases
Level
The sensor is submerged
Interface
The sensor is submerged by the second liquid of
greater thermal conductivity
Figure 1 - CLASSIC 800
Display Panel
