Katadyn EK-24, Инструкция по эксплуатации

Страница: 32 / 43

Katadyn Page 31
After rinsing with water, reassemble the activator by reversing the steps listed above.
15 Troubleshooting
ELECTRIC SHOCK!
Switch off the Mains Switch and disconnect the Mains connection
(230/120VAC) before conducting any work on the Elektro Katadyn System
.
15.1 Flow Low
Flow Low Flow rate through EK below 0.5 m^3/h
• Check if water is available
• Check if the inlet and outlet valves are open
•
Check if there is any restriction in the pipe system
• Check if the Flow Switch is wired correctly
• Check if there are any mechanical damages to the Flow Switch
15.2 Voltage High
Voltage High Voltage on the Activator is above 21.5 V DC.
• Check if there is an open circuit form the Control Cabinet to the Activator
• Check if the Anode(s) is (are) used up. No silver visible on the anode
• Check if the conductivity of the water is according to the technical data in chapter 8
15.3 Voltage Low
Voltage Low Voltage on the Activator is below 0.25 V DC.
• Check if there is an short circuit form the Control Cabinet to the Activator
• Check if the current setting is correct
•
Check if the conductivity of the water is according to the technical data in chapter 8
15.4 Temperature High
Temperature High Cabinet temperature (internal) is above 45°C
• Check if the Temperature Switch inside the Control Cabinet is set to 45°C
• Check to verify if ambient temperature is
≤
40°C
15.5 Overvoltage
Overvoltage Electrical circuit to the Activator is open
• Check if there is an open circuit form the Control Cabinet to the Activator
• Check if the conductivity of the water is according to the technical data in chapter 8