KAT VR WALK Premium Package, Руководство пользователя

Страница: 27 / 28

5.After the base plate shell is installed, the remaining half-side support pillar shell needs to be installed back to the pillar.
Please note that during the installation, the HTC VIVE three-in-one connecting cable and the grounding cable need
to be put through the cable hole.
The two LED wires on the bottom, the one LED wire on the top and the top sensor wire need to reach out of the shell
at the lower end of the support pillar. The three LED wires are to be connected with the power supply of the logo
light controller.
cable hole
Examination after installation of the mechanical structure
Please note the following after the installation:
Check each screw hole and make sure all the screws or bolts are tightened;
Check if there is enough space for heat dissipation surrounding the device and if the air flow is normal;
Check if the power socket supply complies with product specifications;
Check if each product is correctly connected and if those involved with power supply are correctly
connected to the ground;
Check if the connection between the KAT STATION control center and other network devices is normal.
Connection of Grounding Cable
Fasten the metal end onto the wing bolt in the KAT STATION cabinet as shown in the picture, and put the other end
through the cable hole of the cabinet. Insert the other end of the grounding cable on the support pillar into the quick
cable connection terminal as shown in the picture and make sure it will not loosen in a natural state.
27 Starting Installation
cable hole
the chassis of
the control center