2 – 3 HP J SERIES FOUNTAIN
MANUAL
884168 / 2021.1.1
9
5�
Twist the screen clockwise (as viewed from the bottom) so that the flanges in the screen grab the serrated hex head screws. Tight
-
en all three serrated hex head screws to secure the screen to the bottom of the float, being sure not to pinch the power cord. 9/16’’
side of wrench tool required�
6� Using included cable ties (L), attach the unit power cord to one of the rope holes for strain relief as shown below� Unit is ready for
installation into the pond� Any lights or other optional equipment installation (including nozzle selection) should be made at this
time� Refer to instructions included with equipment�
Tighten all 3
screws to secure
float screen
Fig. 14-15
Providing strain relief on the cord helps ensure that its weight
and any strain placed on it in the water will not cause the float
to tilt or cause damage to the unit�
If your Kasco cord comes with a strain relief kit attached, attach
the available link to the float-side knot in the mooring rope, as
pictured here�
Cord Strain Relief
Back to Contents