Kartsana Silver TG-1100, Инструкция по эксплуатации

Страница: 15 / 40

OPERATING AND HANDLING
SILVER STRETCHER
13
Rev.4
28.11.22
TROUBLESHOOTING
COD
DESCRIPTION OF
ERROR
POSSIBLE CAUSE OF
ERROR
SOLUTION
2
The battery Voltage is
below 3V. The battery(ies)
are disconnected or
damaged.
Battery(ies) disconnected
Connect the batteries correctly
in the dock.
Check that the battery cables
are securely connected to the
circuit board.
Damaged battery(ies) Replace with new battery(ies)
3
The battery Voltage is
above 34V
An overload occurred while
the battery was recharging.
(ONLY use the charger
supplied by KARTSANA or
the stretcher for recharging
the batteries.)
Leave the battery
disconnected, preferably in a
cool place for 3 or 4 hours (or
until it does not show error 3
when connected to the
stretcher) for it to discharge.
Check that the batteries have
not suffered internal damage
while discharging caused by
stretcher raising and lowering
movements. It must perform at
least 15 cycles before
discharging.
Damaged battery(ies) Replace with new battery(ies)
4
The stretcher does not
receive voltage from the
ambulance.
The stretcher-rail plug does
not connect properly
Check that the two prongs of
the stretcher plug and the rail
are touching, and that no
foreign objects are between
them.
The ambulance battery is
discharged or damaged.
Charge battery or replace with
a new one respectively.
Power cables incorrectly
connected to either the
ambulance, rail or stretcher.
Check cable connections.
Recommended checking
order: ambulance, rail and
stretcher
One of the copper prongs
on the stretcher plug has
not come completely out of
its housing in the plastic
part.
Check that the plug prongs
gently go in and out of their
housing.
5
The Voltage of the two
batteries is below 18V.
Batteries discharged Charge batteries
6
The stretcher is receiving
voltage through the plug
but the copper prongs
have not been pressed in.
The stretcher is not fully
inserted in the rail.
Position it correctly on the
inside of the rail.
7 No batteries detected Batteries disconnected
Fully insert them in the
fastening plate until you hear a
click.