Bord-Control Panel
ELECTRICAL INSTALLATION
6-1
8 - Indicator lamp for low battery
The low battery indicator lamp comes on if
the body battery charge sinks below 10.8
Volt. Low battery charge can lead to damage
to the body battery.
9 - Mains switch
For switching off the entire 12 Volt living
section of the on-board power supply.
10 - Heating temperature sensor
11 - Charging indicator lamp
When 230 V is connected, the indicator lamp
lights up during charging until the battery is
full.
The monitoring panel is located in the interior
above the body door. It controls all control
and monitoring elements of the 12 V power
supply and gives information at all times on
the condition of the batters, fresh water,
waste water tank, charging activity etc.
1 - Combined display for fresh and waste
water and battery charge status
The display for the fresh and waste water
levels can be switched between the two with
rocker switch 2. Fresh water is to the left, and
waste water is to the right.
Rocker switch 3 shows the battery charge: to
the left is the vehicle battery while the body
battery is to the right.
4 - Standby operation switch with
indicator lamp
In standby mode, all consumers are switched
off except for the entry light, the heating and
the refrigerator. For safety's sake, always set
the standby switch to "Off" when leaving the
vehicle.
5 - Main water pump switch with
indicator lamp
The fresh water pump is put into operation
with the 12 Volt operating switch (9) followed
by the main water pump switch. The indicator
lamp shows readiness for operation.
6 - Duomatic (optional) see Page 5-1
7 - Trumatic C operating element see Page 5-3
8
7
11
9
1
6
5
4
3
2
10
