Karel MS48IP, Руководство по программированию, Страница: 29 / 96

MS48IP Programming Guide
21
8006 03 423### 0542## *
8006 04 4231## 0562## *
8006 05 0##### 0535## *
- If the extension dials “42” and waits, the system sends this number to the
CO as “0532 42”.
- If the extension dials “423” and waits, the system sends this number to
the CO as “0542 423”.
- If the extension dials “018” and waits, the system sends this number to
the CO as “0535 018”.
- If the extension dials “567” and waits, the system does not send this
number to the CO Instead, the system waits the extension to dial the
next 3 digits.
6. If the parameter Y is to be skipped, a “#” should be dialed.
7. If the parameter S is to be skipped, a “#” should be dialed. In such a case, the
dialing is established through any idle line.
8. If the parameter T is to be skipped, a “#” should be dialed. In such a case, the
dialing is established regardless of the time at which the call is established.
9. If the parameter U is to be skipped, a “#” should be dialed. In such a case, the
dialing is established regardless of the day at which the call is established.
10. If the parameter V is to be skipped, a “#” should be dialed. Skipping means
“least cost”. The bigger value of this parameter means the cheaper the route is.
11. After dialing “9”, since the system cannot know which line will be used at that
time, the status of all lines are checked and the extension receives busy tone if
all lines are busy.
But even if dial tone is received it does not mean that an idle line will be
available. Following may happen after the system stops the comparison:
-
If the line is busy, the extension receives busy tone.
-
If the number to be sent to the CO is beyond the External Call Authority of
the extension or this number is restricted by the “8007” coded Call Prefix
Restriction Program , then he receives error tone.
-
If the line through which dialing will be established is not assigned to the
access group of the extension, the extension receives error tone.
Once LCR is activated, the parameter of 8088 coded DTMF Dialing program
takes the value “1”, i.e. the system always regenerates the digits dialed by the
extensions before sending them to the CO
12. If the numbers stored in the private pool or common pool start with the prefixes
defined by parameter P of any LCR location, then the system sends these
numbers to the CO with the prefix defined by parameter R of the LCR location.
13. The “8007” coded Call Prefix Restriction Program restricts the calls of
extensions only if the prefix to be restricted is just the same as the one entered
by parameter P or R of the LCR program.