This Manual is the exclusive property of the Manufacturer. Reproduction, in any form whatsoever, even partially, is prohibited.
Instruction Manual
High pressure piston pumps – Series NMT-EBCW, NMT-EBCH, XLTI-EBCH, XLTI-ESA
Rev. 0
Page 14 of 25
3.7
Products in use
All products used for normal equipment operation such as oils, lubricants and cleaning products must be used in conformity with
the requirements laid down in the producer’s product data sheets.
The oil used in Hawk pumps, series NMT-EBCW, NMT-EBCH, XLT-EBCH, XLT-ESA is: SAE 10W/40.
As explained in Chapter 2, our pumps are made of
ECOBRASS
and
AISI 316
STAINLESS STEEL, and the
supplied
seals
are made of
TEFLON (PTFE
),
FKM (Viton), rubber fabric and NBR.
They must be disposed of in compliance with the specific instructions laid down in the existing laws.
No other products than those specified herein must be used.
If you have doubts, contact the Manufacturer.
3.8
Signage/ID plate
The danger, warning and obligation signs described in the sections above are affixed near/on the pump.
An exact description of the pump, its model, serial number and technical specifications will help our After-Sales Service (where
applicable) to provide our clients with timely and efficient replies.
The pump identification data are specified on the equipment ID plate, as shown below.
Under no circumstance should the ID plates and/or decals intended to provide information and/or
warnings be removed (or re-placed) from the equipment.
FAC – SIMILE
Machine ID plate
