Kärcher KM 130/300 R Bp, Оригинальное руководство пользователя, Страница: 26 / 372

-
9
 Open the side engine panel.
 Loosen counter-nut.
 Adjust sweeping track
 Tighten counter nut.
 Check the sweeping track of the sweep-
ing roller.
 The side-brushes lift up.
 Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
 Set the programme switch to sweep
with roller brush and side brush.
 The side-brushes lift up.
 Set programme selection to "Drive".
 Drive machine backwards.
 Check sweeping mirror.
The width of the sweeping track should lie
between 40-50 mm.
 Set the sweeping track using the two
adjusting screws.
 Check sweeping mirror.
 Drive the waste container up and se-
cure it with the safety rod.

DANGER
Risk of injury! Always apply the safety bar
when the waste container is raised.
 Fold the safety rod for the high empty-
ing up and insert it into the holder (se-
cured).

1 Holder of safety rod
2 Safety rod
 Open the side cover as described in
Chapter "Replace brush roller".
 Release the 6 wing nuts on the side
holding plate.
 Loosen 3 nuts (SW 13) on the front
holding plate.
 Press the side seal down (elongated
hole) until it is about 1 to 3 mm to the
floor.
 Screw in the holding plates.
 Repeat the procedure on the other side
of the appliance.
 Clean the dust filter with the filter clean-
ing button.
몇
WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
1 Lock of appliance hood
2 Cover
 Open the lock, remove the star grip
screw to do this.
 Fold cover forwards.

Open filter cap.
 Fold the filter vibrator forward.
 Replace the dust filter.
 Close the filter cover.
 Unscrew the head lamps.
 Take out the head lamps and pull out
the plug.
Note:
Note the positions of the plugs.
 Dismantle the head lamps.
 Dismantle the head lamp casing and
hold it horizontally because the lamp
unit is not fastened.
 Unlock the bracked and take out the
bulb.
 Insert new bulb.
 Reinstall in reverse sequence.
Note:
Remove the glass of the direction-in-
dicator lamp from its casing to replace the
bulb.
 Open the fuse holder.
 Check the fuses.
 Replace defective fuses.
Note:
The fuse FU 01 (main fuse) is locat-
ed on the electronics casing.
The fuses FU 14, FU 15 and FU 16 are lo-
cated in the electronics casing.
Attention
:
Opening of electronics casing and replac-
ing of fuses only by customer service.
1 Fuse FU 01 (main fuse)
2 Electronics casing
Check and adjust sweeping track of the
side-brush
Adjust the side seals
Manually clean the dust filter
Replacing dust filter
1
2
2
1
Changing the headlight bulb (option)
Changing the blinker bulb (option)
Replacing fuses
FU 01 Main fuse 220 A
FU 02 Seat contact switch 3 A
FU 03 Driver cabin (optional) 10 A
FU 04 Driving direction
switch 5 A
FU 05 Multifunction display 3 A
FU 06 Hydraulic oil cooler 25 A
24 EN