Kärcher B 90 R Series, Руководство по эксплуатации

Страница: 15 / 244

English
15

Danger
Danger of explosion. Do not put tools or
similar on the battery, i.e. on the terminal
poles and cell connectors.
Risk of injury. Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.
The "Pack" model contains built-in batter-
ies.
Î
Swivel the seat to the front.
Figure 3, see cover page
Î Insert batteries.
Note
The two recommended battery types are
stored in different ways inside the appli-
ance.
몇
Warning
Pay attention to correct poles.
Î Lubricate the battery pole with pole
grease.
Î Connect pole using the enclosed con-
necting cable.
Î Connect the connection cable to the
free battery poles (+) and (-).
Î
Insert battery plug.
Î
Raise the safety support und and swivel
seat to the bottom.
몇
Warning
Charge the batteries before commissioning
the machine.
Note
The device is equipped with a safety mech-
anism to prevent total discharge, i.e. when
the permissible minimum capacity is
reached, then the machine can only be driv-
en and existing lamps can be switched on.
In such a case, the battery monitoring sym-
bol on the control console glows red.
Î Drive the appliance directly to the
charging station; avoid any steep gradi-
ents in the process.
Note
While using other batteries (for e.g. batter-
ies from other manufacturers) the total dis-
charge protection level must be reset by the
Kärcher aftersales service according to the
respective battery.

Danger
Risk of electric shock. Observe supply net-
work and fuse protection - see "Charger".
Only use the charger in dry rooms with suf-
ficient ventilation!
Note
Average charging time is approx. 10 - 12
hours.
The recommended chargers (matching the
batteries used) are regulated electronically
and will automatically switch off the charg-
ing process.

Danger
Danger of explosion. Wet batteries can only
be charged with the seat tilted up.
Î Tilt the seat upward.
Î Take the power cord out of its holder
and insert the plug into the socket.
The display will show the charging sta-
tus of the batteries.
Note
All cleaning and drive functions are blocked
during the charging process. The functions
are blocked until a minimum of 90 minutes
has elapsed and the power plug has been
pulled.
Î After the charging process, pull the
power plug and insert into the holder on
the appliance.
Î Tilt the seat upward.
Î Remove battery plug and join it to the
charging cable.
Î
Connect the charger to the mains and
turn it on.
Î Switch off the charger and remove the
plug from the socket after you have fin-
ished charging.
Î Pull the battery cable from the charger
cable and connect it to the machine.
Î Add distilled water one hour prior to
charging; check correct acid level in the
battery. Batteries are marked accord-
ingly. At the end of the charging proc-
ess, all cells must gas.

Danger
Danger of chemical burns. Adding water to
the battery in its discharged state can cause
the acid to leak! Use safety glasses while
handling battery acid and follow the safety
instructions to avoid personal injury or dam-
age to clothes. Should the acid spray on to
the skin or clothes, rinse immediately with
lots of water.
몇
Warning
Risk of damage. Use only distilled or desal-
inated water (VDE 0510) for filling the bat-
tery. Do not add any substances (so-called
performance improving agents), else war-
ranty claims will not be entertained.
Note
Press the emergency-stop button to imme-
diately deactivate all functions and turn the
key switch to the "0" position.
Î
Four floor boards of the pallet are fas-
tened with screws. Unscrew these
boards.
Figure 4, see cover page
Î Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
Î Slide the four support beams included in
the packaging under the ramp.
Î Remove the wooden bars in front of the
wheels.
Figure 5, see cover page
Î Pull the brake lever and push the appli-
ance down the ramp with the level
pulled.
or
Î Release emergency-stop button by
turning.
Î Set main switch to "1".
Î Press the drive direction switch and
slowly move the machine down from the
ramp.
Î Set main switch back to "0".
The procedure for changing the cleaning
head is described in the chapter "Mainte-
nance Tasks".
Keep children away from acid and
batteries
Danger of explosion
Fire, sparks, naked flames and
smoking must be strictly avoided
Danger of chemical burns
First aid
Warning note
Disposal
Do not throw the battery into the
regular waste
Insert batteries and connect
Layout A (Fig. 3A) 180 Ah
Layout B (Fig. 3B) 240 Ah
Charge the batteries
"Pack" model
Model without integrated charger
Low maintenance batteries (wet batter-
ies)
Recommended batteries, chargers
Order No.
Battery pack, 180 Ah,
maintenance-free
(4 batteries) 6.654-124.0
Battery pack, 240 Ah,
maintenance-free
(4 batteries) 6.654-119.0
Charger for mainte-
nance-free batteries 6.654-125.0
Maximum battery dimensions
Layout A B
Length 244 mm 312 mm
Width 190 mm 182 mm
Height 275 mm 365mm
Unloading
Install cleaning head