Kantronics KAM, Руководство пользователя

Страница: 53 / 80

Chapter 7 - Commands and Messages
53
CR ON|OFF default ON
When ON the
SEndpac
character (normally carriage return) is appended to all packets sent in
Convers Mode. Setting
CR
ON and
SEndpac
$0D results in a natural Conversation Mode. Each line
is sent when a CR is entered and arrives at its destination with the CR appended to the end of the
line. If
AUTOLf is ON at the receiving end no overprinting occurs.
CRAdd ON|OFF default OFF
When ON, a CR character is added to any CR character sent to the radio. This is to allow a CR,
CR, LF sequence. This command affects RTTY/ASCII/AMTOR Modes only.
CRLfsup
ON|OFF default OFF
When ON, extra CR and LF characters following a CR are not sent to the terminal.
CStamp ON|OFF default OFF
When ON, the daytime stamp is printed with all
***connected to
and
***disconnected
messages on the display.
CText default blank
Enter any combination of characters and spaces up to maximum length of 128. Entering a sin-
gle % will clear
CText
. This entry specifies the text of the packet to be sent as the first in response
to an accepted connect request provided that the parameter
CMSg
is also ON.
CW
n
This command sets the unit in CW Mode with a Morse speed of
n
. For example, use
CW 30
to
set a transmit CW speed of 30. Also, when receiving CW, estimate the speed and then enter Morse
with that speed. For example, if the code sounds like 20 WPM, then enter
CW 20
. Auto ranging for
CW speed tracking is ± 20 WPM from the speed selected. If no value is entered for n, the speed
specified in
CWSpeed
will be used.
CWBand
n
default 200
This command sets the bandwidth of the unit input filters for CW in Hertz.
CWSpeed n default 10
This command sets the default. MORSE speed used when entering the CW Mode with no pa-
rameter. This speed is also used if
PMode
is set to CW.
CWTone
n
default 750
This command sets the CW filter center frequency for receiving CW in Hertz.
DAytime
yymmddhhmmss default 00/00/00 00:00:00
If the parameter yymmddhhmmss is present, the software clock/calendar is set for MHeard
logging, CStamp and MStamp functions. If there is no parameter the daytime is displayed in a
form depending on the setting of the
DAYUsa
flag. When entering the daytime digits, enter in pure
number sequence with no spaces, dashes or slashes. For example: 860102223000.
DAYTWeak
n
default 8
This parameter may be set to any value between 0 and 15. It is used to tweak the clock for ac-
curate time keeping. Increasing the parameter will slow the clock, decreasing the parameter will
speed up the clock. Each count corresponds to .85 seconds increase or decrease per day. Ambient
temperature will affect the clock to some degree.
DAYUsa ON|OFF default ON
When ON, the daytime stamp is displayed in the form common in the USA: month/day/year.
When OFF, the daytime stamp is displayed in the form common in Europe: day/month/year.