Kantronics KAM, Руководство пользователя

Страница: 56 / 80

Chapter 7 - Commands and Messages
56
FSkinv ON|OFF default OFF
This command controls the polarity of the FSK output of the HF radio connector. When OFF,
MARK is open-collector and SPACE is grounded. When ON the polarity of MARK and SPACE are re-
versed.
FUlldup ON|OFF default OFF
When ON, the VHF modem is run full duplex. No HF operation is allowed when
FUlldup
is ON.
Gateway ON|OFF default OFF
When ON, packets can be digipeated from one radio to the other using the digipeater callsign
specified by MYGate .
Headerln ON|OFF default OFF
When ON a carriage return is output between the header and text of monitored packets. This
causes the packet header and/or time stamp to be displayed on one line, with the packet text dis-
played below it on the next line.
HELp
This is an immediate command which causes a display of all possible commands.
HId ON|OFF default OFF/OFF
This command is used to control sending of identification packets by the KAM. If ON, an identi-
fication packet will be sent every 9.5 minutes PROVIDED THAT packets are being digipeated
through your station. If OFF, periodic identification packets will not be sent. This command should
be ON if
ALias
or
Gateway
is ON. See
Id
command for description of identification packet.
Id
This is an immediate command. When entered, an identification packet, will be forced. This
command can be used to insure that your station identification is the last transmission before tak-
ing the station off the air. The ID packet is an unnumbered information (UI) packet whose data
consists of your station identification as set in
MYcall
. If
DIGipeat
is ON, an "/R" is appended after
the callsign. If
ALias
is ON,
MYAlias
with a "/D" appended is also in the packet data. If Gateway is
ON,
MYGate
with a "/G" appended is also in the packet data. This packet will be addressed to "ID"
with any digipeats as specified in the Unproto command.
INvert
ON|OFF default OFF
When ON, signals received in RTTY or ASCII are inverted. While in RTTY, ASCII, or AMTOR
Modes, entering CTRL-C I command will toggle the inversion ON and OFF.
Kamport HF|VHF default VHF
When the unit enters the KAM mode, this parameter determines whether the current stream is an
HF stream or a VHF stream.