Kantech KT-NCC, Руководство по установке

Страница: 33 / 46

DN1611-1809 33
KT-NCC Installation Manual
Configuring with a Static IP Address (continued)
Figure 18: Gateway Window - Ethernet Port #1 Tab
9. Enter the KT-NCC
MAC address
. The first 6 numbers in the MAC address (00-50-F9) cannot be
modified.
Note:
The MAC address can be found on the KT-NCC PCB, underneath the Ethernet #1. It is a 12-
digit hexadecimal code, with each two digits separated by a dash (00-50-F9-xx-xx-xx) Refer
to Figure 22: on Page 39 to locate the MAC address on the KT-NCC board.
10.The Online option is checked by default.
11. Check the
Use the following IP Address
option.
• Select the option
Use the Following IP Address.
• Enter the
IP address
of the KT-NCC.
• Enter the
Subnet Mask
address.
• When necessary, enter the
Gateway (Router)
that the Network Administrator provided you.
• Port
18710
is automatically assigned by default. It is advisable not to modify it.
• The option
Broadcast configuration
is selected by default. Leave this option as is.
12.Click the
Save
icon and close the Gateway dialog.
13.To verify if the server is communicating with the KT-NCC, you can monitor the incoming messages in
the Desktop Message list. (It may take a few minutes between saving the configuration to the first
message broadcast to the server.) Or, you can check the connection status in the Connection List
(See instructions on page 37).
14.If you have more than one KT-NCC gateway, configure them all at this time.