Kantech KT-NCC, Руководство по установке

Страница: 28 / 46

28
DN1611-1809
Configuring DHCP with Customer Server IP Address (continued)
Figure 13: Gateway Window - Ethernet Port #1 Tab
9. Enter the KT-NCC
MAC address
. The first 6 numbers in the MAC address (00-50-F9) cannot be
modified.
Note:
The MAC address can be found on the KT-NCC PCB, underneath the Ethernet #1. It is a 12-
digit hexadecimal code, with each two digits separated by a dash (00-50-F9-xx-xx-xx) Refer
to Figure 22: on Page 39 to locate the MAC address on the KT-NCC board.
10.The Online option is checked by default.
11. Select the
Obtain an IP address automatically
option.
12.Port
18710
is automatically assigned to the KT-NCC by default. It is advisable not to modify it.
13.By default, the
Enable broadcast assignation
box is checked. Leave it to default.
14.Click the
Save
icon.
15.To verify if the server is communicating with the KT-NCC, you can monitor the incoming messages in
the Desktop Message list. (It may take a few minutes between saving the configuration to the first
message broadcast to the server.) Or, you can check the connection status in the Connection List
(See instructions on page 37).
16.If you have more than one KT-NCC gateway, configure them all at this time.