KAM E-IAS, Руководство пользователя

Страница: 15 / 17

EIASMANUAL 0918 KAM CONTROLS, INC.
14
M A I N T E N A N C E C O N T I N U E D
10.
11.
12.
13.
14.
15.
FIG. 4-8
Install new 2-022 O-rings inside both sides of the Sample Chamber.
Apply a small amount of grease around the inside of the installed 2-022 O-rings.
Install new Seal Bushing Assemblies inside both sides of the Sample Chamber.
Apply grease around the inside of the new Seal Bushing Assemblies.
Insert the Linear Actuator back through the Sample Chamber. (Fig. 4-8) The fit should be tight and may require
some force. Ensure that both Seal Bushing Assemblies are in place inside the Sample Chamber when done.
Apply Loctite 242 to the threads and tighten in place using 1 1/2" wrench and 1 3/4" wrench.
Loctite 242
1 1/2" Wrench Flat
1 3/4" Wrench Flat
Replace 2-013 O-ring from the sample shaft. (Fig. 4-9)
Replace 2-004 O-ring on the sample check valve.
Replace spring if necessary.
Insert check and spring back into the sample piston.
Clean the sample shaft threads.
Screw the sample piston on to the sample shaft by holding the shaft with a 9/16" wrench and using an 11/16"
wrench to turn the sample piston.
2004 O-ring
2013 O-ring
Spring
Sample Shaft Threads
FIG. 4-9
16.
17.
18.
19.
20.
21.