KAESER CSD 75, Руководство по обслуживанию, Страница: 42 / 81

Maintenance
9 --- 37
Remove cover panel (3, siee chapter 9.2).
To open the air filter housing:
Open the snap fasteners (1) on the dust collector (3) and remove the dust collector (3)
with the insert.
Take the insert out of the dust collector (3).
Pull out the air filter cartridge (4) by turning slightly.
Clean the air filter housing, dust collector, insert and sealing surfaces.
Cleaning the air filter cartridge (4) by tapping:
Tap the air filter cartridge several times on the front with the ball of the hand.
Do not use excessive force otherwise the air filter cartridge may be
damaged.
Clean all sealing surfaces.
Cleaning the air filter cartridge with compressed air:
Use dry, compressed air blowing at a pressure of not more than 30 psig at a slant
from the inside to the outside of the air filter cartridge surfaces.
Do not clean the air filter cartridge with fluids. If the air filter cartridge
is heavily contaminated or was already cleaned several times (max.
five times), replace.
Compressed air shall not be used for cleaning purposes except where
reduced to less than 30 psig and then only with effective chip guarding
and personal protective equipment. (OSHA CFR 29 § 1910.242)
To close the air filter housing:
Insert the air filter cartridge (4).
Note the insertion mark on the dust cap.
Guide the insert into the dust collector (3).
Put back the dust collector (3) and close the snap fasteners (1).
Close all maintenance doors and reattach all cover panels.
Attention!
Attention!
Attention!