KAESER CSD 75, Руководство по обслуживанию, Страница: 25 / 81

Installation
6 --- 20
Solution B: Exhaust Air used for Space Heating
The hot air is forced through a conduit (see chapter 1.6) into the room to be heated.
Consult the manufacturer with regard to length of conduit and for
maximum allowable pressure drop for this compressor package.
Safe operation of the compressor package is guaranteed only if the temperature limits (see
chapter 1.6) of the cooling air are adhered to.
In confined places, the minimum distance between one side of the
compressor package and any wall can be reduced.
It is imperative that the minimum distance shown in the drawing is kept
to, to allow servicing work to be carried out without hindrance.
16
Measurements in inches
6.2 Connection of the Compressed Air Supply
The package is set up ready to operate. Connect the discharge outlet
of the compressor to the system pipework using a flexible hose line
(or axial compensator) and isolation shut-- off valve with drain.
Use the NPT adapter if necessary.
6.3 Electrical Connection
The main power supply and overcurrent protection must be installed
by a qualified electrician in accordance with NEC, OSHA and any appli-
cable local codes.
For fuse and wire recommendations, see chapter 1.4
The compressor is wired ready for connection to the main supplies. Feed the supply cable
with cores marked L1, L2, L3 and PE through the cable inlet in the base frame into the con-
trol box and connect to the terminals marked L1, L2, L3 and PE in this box.
Maximum dual element time -- delay fuses are selected according to
1996 N.E.C. Article 240 -- 6, 430 -- 52 and Tables 430 -- 148 & 150.
Select multi-- strand copper core wire at 40
•
C ambient temperature
according to 1996 N.E.C. 110 -- 14(c), 220 -- 3, 310 -- 15, Table 310 -- 16,
430 -- 6, 430 -- 22 and Tables 430 -- 148 & 150.
Wire temperature rating:
Attention!
Attention!
Attention!
Attention!