1 7
Settings –
Advanced Setting Menu
10
This is the section in which the parameters are not used very often.
1 7 10
2 3
5 6
8 9
11 12
7
4
1
10
30
Apply
▲ +
▼ -
◄
0000
2 3
5 6
8 9
11 12
7
4
1
10
30
Cancel
OK
ESC
Enter ΔT On Delay time
Enter ΔT On Delay time
0000
Save
changes
1
This is the section in which the holding time between steps during step activating, is entered. The
value is setup to the required step by using up and down keys starting from the digit where the
blue line is. Then, left key is pressed and the blue line moves next to left digit. All values are
entered in the same way by using the up and down keys. Press “Apply” key inorder to take
Δ
T on
switching time into memory. “Save changes” message will appear on the screen. When “OK” key
is pressed, the value is taken into memory.
In case at least one of ΔT on
or ΔT off time is setup to any
value rather than zero and the
device runs in quick mode, quick
mode is canceled automatically.
1 7
Settings –
Advanced Setting Menu -
Δ
T off Delay Time (0 – 3600 sec)
10
2 3
5 6
8 9
11 12
7
4
1
10
30
Apply
▲ +
▼ -
◄
0000
2 3
5 6
8 9
11 12
7
4
1
10
30
Cancel
Okay
Exit
Enter ΔT Off time
Enter ΔT Off time
0000
Save
changes
This is the section in which the holding time between steps during step de-activating, is entered.
The value is setup to the required step by using up and down keys starting from the digit where
the blue line is. Then, left key is pressed and the blue line moves next to left digit. All values are
entered in the same way by using the up and down keys. Press “Apply” key inorder to take
Δ
T off
switching time into memory. “Save changes” message will appear on the screen. When “Okay”
key is pressed, the value is taken into memory.
sec
sec
2
1 7
Settings -
Advanced Setting Menu –
current flow direction detection
10 3
This is the section in which the function of searching of current transformer polarity directions are
activated or de-activated. In case “Activated” is selected, internalization of current transformer
direction is always “On”, and only checks the directions when the device is powered. If “Off” is
selected, then the device internalize the current transformer directions at once and do not change
it. The “Off” choice should be selected for some loads (producing negative active load).
The required status for function is selected by using the up
and down keys. Press “Apply” key inorder to take this parameter
into memory. “Save changes” message will appear on the screen.
When “Okay” key is pressed, the value is taken into memory.
2 3
5 6
8 9
11 12
7
4
1
10
30
Apply
▲ +
▼ -
Enable
Direction Detection Status
Settings –
Advanced Setting Menu -
Δ
T on Delay Time (0 – 3600 sec)
ΔT on
2
ΔT off
1
2
1
15
In case at least one of ΔT on
or ΔT off time is setup to any
value rather than zero and the
device runs in fast mode, quick
mode is canceled automatically.
In case internalization of direction is activated, internalization of
current transformer direction is always “On”, and only checks the
directions when the device is powered. In case the ends of
current are changed while the device is running, it can not detect
this. It' s needed to turn off and on again.
