Kaco blueplanet 50.0 TL3 S, Руководство по эксплуатации

Страница: 19 / 68

Electrical connection
Operating instructions KACO blueplanet 50.0 TL3 S/Basic/M/XL Page 19
EN
Authorised electrician
PV- PV+
1
2
5
1
3
4
5
Figure 18: Connection area: blueplanet 50.0 TL3 Basic + M Figure 19: Connection area: blueplanet 50.0 TL3 XL
Key
1 DC isolator switch (not present in S version) 4 Cable fitting (M63) for AC connection
2 Cable fitting for DC connection (M version) 5 Earthing bolt
3 Connector for DC connection (XL version)
7.2.3 Cable and fuse requirements
Note the following cable cross-sections and the required tightening torques:
AC connection DC connection (S, Basic + M) DC connection (XL)
Max. cable cross-section
without wire sleeves 95 mm² (AL or CU) 95 mm² (max. 120 mm²) - Use an
AL-CU cable lug for an aluminium
cable. 2.5-6 mm² (10x DC plug
connectors)
Max. conductor cross-sec-
tion 95 mm² with wire
sleeves 95 mm² (max. 120 mm²) Screw M8 -
ring cable lug on M8/Ø 9mm² -
Length of insulation to be
stripped off 25 mm depending on the cable lug used
Tightening torque 10 Nm 15-22 Nm - (DC plug connector)
Recommended cable type PV1-F or UL-certified solar cables (ZKLA), AWG 10–14
Table 5: Recommended cable cross-sections and tightening torques
The unit versions Basic, M and XL also differ in the following ways:
S, Basic M XL
DC overvoltage protection
- Base
Base + overvoltage conductor (SPD),
type I + II
AC overvoltage protection
- Base
Base
Overvoltage conductor (SPD) - Can be retrofitted on
the DC and AC side DC side built-in, can be retrofitted on
the AC side
String fuses To be provided externally on-site Recommended 1100V, gPV, max. 20A
Combiner box with DC isolator
switch
To be provided externally on-site Installed internally
Protection class 1
Overvoltage category III