Kaba E-Plex 5900, Руководство пользователя

Страница: 11 / 37

11/37
11
13. Lock keypad commands
Using keypad commands, a user can do maintenance operations on the lock.
The following table lists the modes and available commands.
Mode Commands
Factory Only one command is available in factory mode:
ƒ
Set construction mode pin
Construction All commands, without any restriction, are available in factory mode:
ƒ
Set construction pin (in factory or construction mode)
ƒ
Configure lock using an admin card
ƒ
Set date
ƒ
Set time
ƒ
Set temporary passage mode duration
ƒ
Activate/deactivate passage mode
ƒ
Activate/deactivate lockout
ƒ
Perform diagnostics
ƒ
Identify the lock model
ƒ
Start a maintenance unit communication session
Access All commands with the exception of ‘Set construction pin’ are available IF the related
privileges are granted (see table below).
The following table lists the privileges required to access keypad commands. These privileges are REQUIRED
once the lock is configured (using an admin card).
Important: The privileges must be assigned on the headend
system and stored on user cards.
Privilege Command
Keypad programming
ƒ
Set date
ƒ
Set time
ƒ
Perform diagnostics
ƒ
Identify the lock model
Lockout
ƒ
Activate/deactivate lockout
Maintenance unit
programming
ƒ
Start a maintenance unit communication session
Passage mode
ƒ
Set temporary passage mode duration
ƒ
Activate/deactivate passage mode
Admin card configuration
ƒ
Configure lock using an admin card
13.1 Entering keypad programming mode
Keypad programming mode is entered differently, depending on the current operation mode. Start the keypad
programming mode by pressing the # key followed by PIN #, if the lock is in construction mode, for example. The