16
4
ATTACH BRACKET TO REAR TILT LEG
Attach the rear Tilt Leg to the Tilt Connector using two M10
T-bolts and two Serrated Hex Nuts. Make sure the connector is
flush along bottom of the rail.
Torque: 25.8 ft-lbs (35Nm).
Note: If installing a 7 degree landscape configuration, do not
tighten the bottom hex nut on the connector. Continue to Step 5
and then skip to Step 7.
Materials required: Tilt Connector Set, rear Tilt Leg, M10 T-Bolt
(use bonding T-bolt with dark rail), Serrated Hex Nuts.
5
ATTACH TILT CONNECTOR TO FRONT LEG
Attach the Tilt Connector slot on the front Tilt Leg. Attach the
connector using one M10 T-bolt and one Serrated Hex Nut.
Torque: 25.8 ft-lbs (35Nm).
Ensure the indicators on the end of the T-bolt shaft are per-
pendicular to the channel, indicating the T-bolt head is properly
engaged.
Materials required: Tilt Connector Set, rear Tilt Leg, front Tilt Leg,
M10 T-Bolt (use bonding T-bolt with dark rail), Serrated Hex Nuts.
6
ATTACH TILT LEG SET TO L-FEET OR T-FEET
Position the leg set assembled in Steps 4 and 5 above so that it
is flush against the vertical wall of the L-Foot or T-Foot X. Hand
tighten the leg set to the L-Feet or T-Feet with M10 T-bolts and
Serrated Hex Nuts.
Using appropriate alignment techniques, (i.e. level, string line, etc.)
ensure the appropriate tilt angle and roof clearances are obtained.
Torque: 25.8 ft-lbs (35Nm).
Ensure T-bolts are properly engaged in the rail channel via the
alignment indicator on the end of the bolt shaft.
Materials required: Tilt Leg Set, L-Foot or T-Foot X, M10 T-Bolt (use
bonding T-bolt with dark rail), Serrated Hex Nut.
Содержание Everest CrossRail 44-X
Страница 22: ...22 Notes ...
Страница 23: ...23 Notes ...