K2 Systems Everest CrossRail 44-X, Руководство по сборке

Страница: 15 / 24

15
3
OPTIONAL: INSTALL EVERFLASH AND L-FOOT
Line up pilot hole with the EverFlash flashing hole.
Insert the lag bolt through the EPDM bonded washer, the
L-foot, the gasketed hole in the flashing and into the rafter.
Torque: The range is between 8.3 - 11.6 ft-lb depending on
the type of wood and time of year. The visual indicator for
proper torque is when the EPDM on the underside of the
bonded washer begins to push out the sides as the washer
compresses. If using an impact wrench to install the fasten-
ers, be careful not to over torque the fastener. You may need
to stop and use a ratchet to finish the install.
Materials required: Bolt, EverFlash L-foot and hardware,
torque wrench with 13 mm deep socket.
OPTIONAL: INSTALL T-FOOT X AND CHEM LINK E-CURB
OR
If installing the E-Curb, please follow the manufacturer's gui-
delines for installation at https://chemlink.com/?s=e+curb.
Apply M-1 to the bottom of the E-Curb rings and place
them around the T-Foot. Press the rings firmly in place until
excess adhesive extrudes from the outside edges.
Apply M-1 along the outside edge of the instlaled E-Curb
rings and smooth it out.
Fill the E-Curb with to the brim of the rings with the 1-Part
sealant.