User information
Angled mincer WW 130/160
WWD130
10.06.2022
Speicherdatum 10.06.2022 11:53:00
Seite 7
2 Transport, installation and commissioning
2.1
Declaration of conformity
The declaration of conformity to the EC machine guide lines is
included in the accompanying documents. The declaration of
conformity applies for machines delivered under contract and for
proper operation. It is no longer applicable if essential parts or the
mode of operation are changed without the consent of the
manufacturer
2.2
Obligations on the operaton
The operator must instruct personnel in proper use of the machine
in accordance with the operating instructions. It is recommended to
keep written verification of compliance with the instructions.
The operator is obliged to observe locally applicable regulations,
e.g.:
- acquisition of an operating licence,
- hygiene regulations,
- safety at work regulations and employment restrictions,
- supply and disposal provisions,
- emission and environmental protection provisions.
2.3
Instructions for handling, transport and storage
The machine is delivered with installed worm and cutter assembly.
It must be stored in a dry room. Further transport is best done with a
fork lift. The entire machine must be supported by the fork of the
fork lift.
2.4
Information about noise
The noise level of the meat grinder amounts 70 dBA, measured
according to ISO 3744.
2.5
Space requirements for operatio
The workplace is in front of the machine at the side. The machine
must be accessible from all sides for cleaning and maintenance
(approx. 50 cm at the sides and rear of the machine). Not including
the workplace for the operator, the space requirement is approx.2m
wide and 1,5 m deep.
2.6
Installation requirements
The machine should be installed on a firm, water-impermeable and
easily cleaned surface. The max. permitted slope is 3%, the per-
mitted floor loading must be at least 1000 kp/m². The installation area
must be in accordance with the locally applicable hygiene and
workplace regulations. The illumination intensity must be at least 300
Lux.
