UX-Z7MDR
1-20 (No.22042)
2.3.2 Removing the TRAMECHA Assembly
(Refer to Figs. 6 to 9.)
• Remove the CL. base assembly and tray.
Reference:
The TRAMECHA assembly can be removed without removal
of the mechanism P.C. board.
(1) If the TRAMECHA assembly is lowered and it is located out
of the PLAY position, turn the idle gear in the arrow-marked
direction so that the hole in the part f of the tray gear meets
the hole on the CL. base assembly. (Set the TRAMECHA
assembly at the PLAY position.)
(2) Remove the three screws
B
fastening the
TRAMECHA assembly and then remove the
TRAMECHA assembly upwards from the front side.
(3) At the same time, remove the spring from the groove of the
CH. base assembly in the part
g
of the TRAMECHA as-
sembly.
Note:
When reinstalling the TRAMECHA assembly:
• Check to see if the spring is properly engaged with
groove of the CH. base assembly in the part
g
of the
TRAMECHA assembly.
• After making sure that the three insulators of the
TRAMECHA assembly are properly set on the boss-
es of the L. base assembly's guide, fasten them
with the screws.
Fig.6
Fig.7
Fig.8
Fig.9
B
B
Idle gear
TRAMECHA
assembly
B
Tray gear
Part g
Tray gear
Part f
L. base assembly
Spring
Part g
Spring
Groove of CH. base assembly